On Tue, 05 Aug 2014 18:03:48 -0400, "G. Ross"
wrote:

Imagine a very shallow "V". I noticed while cutting some 2 x 2's.
Put a straight edge on it and the inner portion of both sides is about
1/8 inch back from the straight edge. So far I haven't found the
manual, but the whole fence is one piece of cast aluminum and I can't
imagine straightening it. Any ideas? I tried wedging the center
portion forward but it lives up to it's name. It is extremely ridgid.

Sub-fence? It'll cost some cut length but it's better than diagonal
cuts.