DIYbanter - View Single Post

[email protected]

On Thu, 31 Jul 2014 22:25:50 -0400, wrote:

On Thu, 31 Jul 2014 09:25:06 -0400, "Mike Marlow"
wrote:

Michael wrote:

I can't decide which is better, the square or the star? Which is less
likely to strip?

Personally, I came to like the square drives because I found them to be far
superior to a philips drive, but since I went to star drives, I don't think
I'll ever go back unless the screw I need does not come in star. Just watch
your drive tips. They last a long time but at some point they will start to
round and you'll want to replace them. Like I say though - they will last a
long time.
By "star" I assume you mean Torx??? They are good, but they will
strip a lot easier than the square "robertson" Takes a lot to wear or
damage a robertson driver to the point it will slip.

I find exactly the opposite. Torx (star) are much better. I find the
screws aren't nearly precise enough for the Robertson (or "square head
recess") to work as well as it should.