On 7/27/2014 5:17 PM, Michael A. Terrell wrote:

wrote:

On Tuesday, July 22, 2014 12:15:42 PM UTC-4, wrote:
Does anyone have schematics or suggestions for repairing a Tek P6563A scope probe? The problem is the signal line has only a 390 ohm resistance to the shield as measured with a DMM.

If you have a x1 probe and it's not connect to the scope (or any other piece of test equipment) then the resistance should be near infinity.


It is 20X, with the ID pin.


Then it must be 20 times infinity with the ID pin :-)
Mikek


---
This email is free from viruses and malware because avast! Antivirus protection is active.
http://www.avast.com