Thread: P6563A Tek probe repair?
View Single Post
  #20   Report Post  
Posted to sci.electronics.repair
Michael A. Terrell Michael A. Terrell is offline
external usenet poster
  
Posts: 12,924
Default P6563A Tek probe repair?

wrote:

On Tuesday, July 22, 2014 12:15:42 PM UTC-4, wrote:
Does anyone have schematics or suggestions for repairing a Tek P6563A scope probe? The problem is the signal line has only a 390 ohm resistance to the shield as measured with a DMM.

If you have a x1 probe and it's not connect to the scope (or any other piece of test equipment) then the resistance should be near infinity.


It is 20X, with the ID pin.


--
Anyone wanting to run for any political office in the US should have to
have a DD214, and a honorable discharge.
Reply With QuoteReply With Quote