Bob Engelhardt wrote:
On 7/21/2014 4:13 PM, rangerssuck wrote:
...The groove I need to make is a truncated V 15/16" wide at the
top, 3/8" wide at the bottom and 1/4" deep. ...

How much of this groove do you need to make? One time? Or
production?

Can it be done by using a 45° vee bit and a standard plunge bit ? You might
be able to regrind the angle of a 45° chanfer bit and cut the pilot off
and use it to angle the sides of a 3/8" groove .

--
Snag