Metal advice needed
On Wed, 09 Jul 2014 08:30:04 -0500, "Lloyd E. Sponenburgh"
lloydspinsidemindspring.com wrote:
" fired this volley in
:
It is just a torch, but with a very high temperature. So it does not
work well with ordinary brazing rod.
Don't heat the rod, Don, heat the work.
Brazing is _soldering_. I normally don't even have the rod in the 'zone'
until the work is hot enough to flow the filler.
LLoyd
The only way to braze PROPERLY even with a gas torch. Heating the rod
with a gas torch can work well in combination with heating the work if
the rod is a bit too large for the job.
|