On 6/7/2014 3:46 AM, Kennedy wrote:
On 07-Jun-14 10:17 AM, Tom Gardner wrote:
I need to build a method of heating part of a plastic handle, kinda'
like this one:

http://www.amazon.com/Better-Brush-U.../dp/B006GP591I

I need to bend it 20 degrees at the neck. I have a few heating elements
from water heaters or I'll buy the best candidate, whatever I can
control. Or, I'd buy the hole kit-n-ca-bootle off the shelf. Any
suggestions?


Would directed hot air be quicker?

Might be easier to generate & control too.



Yep, used a heat gun for prototypes.