On 6/7/2014 1:10 AM, Larry Jaques wrote:
On Fri, 06 Jun 2014 22:17:49 -0400, Tom Gardner Mars@Tacks wrote:
I need to build a method of heating part of a plastic handle, kinda'
like this one:
http://www.amazon.com/Better-Brush-U.../dp/B006GP591I
I need to bend it 20 degrees at the neck. I have a few heating elements
from water heaters or I'll buy the best candidate, whatever I can
control. Or, I'd buy the hole kit-n-ca-bootle off the shelf. Any
suggestions?
I wonder if one of the flexible acrylic bending heat strips would work
for you. What temperature are you after? From what plastic are the
handles made?
What kind of speed/daily qty are you looking for? That might drive
answers more into the realm of your wishlist.
--
It is characteristic of all deep human problems that they are
not to be approached without some humor and some bewilderment.
-- Freeman Dyson
New product, don't know. They are PVC...I think.