Thread: Controlling heating elements in a heat tunnel
View Single Post
  #2   Report Post  
Posted to rec.crafts.metalworking
Tom Gardner[_6_] Tom Gardner[_6_] is offline
external usenet poster
  
Posts: 1,624
Default Controlling heating elements in a heat tunnel
On 6/6/2014 10:17 PM, Tom Gardner wrote:
I need to build a method of heating part of a plastic handle, kinda'
like this one:

http://www.amazon.com/Better-Brush-U.../dp/B006GP591I

I need to bend it 20 degrees at the neck. I have a few heating elements
from water heaters or I'll buy the best candidate, whatever I can
control. Or, I'd buy the hole kit-n-ca-bootle off the shelf. Any
suggestions?


Oh, there won't be any bristles in the brush at the time of the bend.
Reply With QuoteReply With Quote