"dadiOH" wrote in message

"SteveB" wrote in message

I want to make an extension to my dining room table, approximately3' x
4'. I want to match the color, stain, and edge to the existing table.
it will bolt on to the existing metal table frame on one side with two
bolts, and have one leg set on center about 18" in from the edge. I
anticipate using 1x4 about 4" in from edge (approx) to match existing to
beef it up and keep if from torquing.

What would be a very good furniture grade 3/4" plywood to buy for this
project? Going to rout the edge to round with the little edge on there.

The same species as the existing. Anything else and you are buying
problems.

The face veneer is what I'm talking about. Core doesn't matter all that
much, will likely be poplar or lauan depending upon where the ply was made.

--

dadiOH
____________________________

Winters getting colder? Tired of the rat race?
Taxes out of hand? Maybe just ready for a change?
Check it out... http://www.floridaloghouse.net