Gunner Asch wrote:
On Tue, 27 May 2014 23:21:28 -0500, "Terry Coombs"
wrote:

Was involved in the fabrication of a drywall lift to hold my
sheetrock up . Makes ceilings a snap . The brackets were made with
the help of my vise and a hammer . The pulley at the bottom below
the winch was machined from 1 1/2" aluminum bar stock on my Wards
PowrKraft lathe . The only materials purchased for this project was
the 2x4 lumber , everything else I had on hand . It works absolutely
swell .

http://s991.photobucket.com/user/Sna...?sort=3&page=1


Nicely done!

Thanks !

--
Snag