On 5/28/2014 12:21 AM, Terry Coombs wrote:
Was involved in the fabrication of a drywall lift to hold my sheetrock up
. Makes ceilings a snap . The brackets were made with the help of my vise
and a hammer . The pulley at the bottom below the winch was machined from 1
1/2" aluminum bar stock on my Wards PowrKraft lathe . The only materials
purchased for this project was the 2x4 lumber , everything else I had on
hand . It works absolutely swell .

http://s991.photobucket.com/user/Sna...?sort=3&page=1



Nice to have a few firing synapses!