Hello,
I have a large walnut bowl blank (actually two). They are around 18"
in diameter and I suspect weigh about 45-50 lbs apiece. I have a PM
3520 and an 8" Oneway faceplate, and a SuperNova with the power jaws
(3"). I am a little nervous about turning something this large, but I
want to! I usually put the face plate on the top of the bowl and cut
the outside and the fixing for the chuck and then turn it around and
cut out the inner portion of the bowl. I will use the tail stock as
much as possible.
Any other considerations I am not thinking about? I have a new Sorby
bowl gouge and a wolverine jig. I want this to be pretty, so any help
you can offer I'd appreciate.

When I get these I also have two large Aromatic Cedar (17") and four
17" Maple blanks waiting. All these are green.

Thanks for your help.

RP