Thread
:
Gasket making
View Single Post
#
22
Posted to rec.crafts.metalworking
Mike Spencer
external usenet poster
Posts: 164
Gasket making
writes:
ObMetalworking: The Wisconsin was intended to drive a 300# air hammer
but turned out not to be big enough. A 3-cyl Deutz diesel *is* big
enough.
The VG4 doesn't make as much power as its size might make you expect!!
The Wisconsin 4 (I forget the model#) is about 24 HP, enough to run
the hammer at idle but not under load. The Deutz is ca. 40 HP. The
hammer was originally run from a 15HP 400V 3PH motor. I salvaged the
motor's shaft to use as a jackshaft between diesel and hammer.
--
Mike Spencer Nova Scotia, Canada
Reply With Quote
Mike Spencer
View Public Profile
Find all posts by Mike Spencer