On Fri, 18 Apr 2014 20:00:16 -0700, SteveB wrote:

I need to make a gasket. It will be about 2 x 3 inches. Pretty simple
stuff. I made one before for my welder carburetor. IIRC, I laid a
piece of paper on it, and rubbed it with dirty fingers until I got a
pattern, then carefully cut it out. It lasted a long time, and would
have lasted longer, but I left it full of gas, and it varnished.

I have cleaned the carb really well, and blown out all the channels and
chased them with pipe cleaners.

I figure to use the piece of white paper again. There are only four
bolt holes, and they have a lot of room for error. I figure this time,
I'll use an X-Acto knife to cut out a lot of the bigger pieces, and a
improvised punch to get the bolt holes.

Any tricks to gasket making? I have enough material to make about four
in case I mess up. Just go slow and easy, I guess. I was going to use
a tiny ball peen to cut off at the outside edges, but decided to leave
about 1/8+" sticking out so I don't have to worry about having too close
tolerances, and having a potential leaking spot. I can just cut outside
the line with scissors, and get it pretty close.

I thought of taking a digital picture, and enlarging it to exact
duplicate scale, and then using that for a template to cut the gasket on
a flat piece of plywood. Might take a little time, but I think I can do
it easily, just include a tape in the pic, and keep adjusting and
printing until it prints dead on.

What would you do?

Steve

Id take the gasket material, lay it on the carberator..and tap it
firmly with a plastic or brass hammer..alll over the top of the
gasket.

Then Id remove the gasket and cut out the places indicated.

OR..Id put a little bit of Dyekem on the joint, and before it
hardens..lay the gasket on the dyekem and push down. Then after a
moment or 3..lift straight up..then cut away the indicated areas.

Its not..not rocket science.


--

"
I was once told by a “gun safety” advocate back in the Nineties
that he favored total civilian firearms confiscation.
Only the military and police should have weapons he averred and what did I think about that?

I began to give him a reasoned answer and he
cut me off with an abrupt, “Give me the short answer.”

I thought for a moment and said, “If you try to take our firearms we will kill you.”"

---
This email is free from viruses and malware because avast! Antivirus protection is active.
http://www.avast.com