On Mon, 17 Mar 2014 14:00:02 -0700, SteveB wrote:

I'm going to make some squirrel traps fashioned on some I saw that work
pretty good. Basically, I'm going to use concrete wire, and lay them
together to get smaller squares. I need to know what you would suggest
to weld them together. I just got a new 115? Victor torch set, the
small one, so could use brazing wire (?). Would I use precoated wire,
or flux powder or paste? Or I could dial down the Miller 180 with some
.024" wire, and hope not to to have too many burn throughs. Which one
would you use?

Steve
I vote for the Miller. If it's anything like my Lincoln SP125+ it
will work very well and FAST. If burn through becomes a problem
reverse the polarity.
Eric

---
This email is free from viruses and malware because avast! Antivirus protection is active.
http://www.avast.com