SNIP

I can but I feel your reply to my honest attempt to help you is a bit
adversarial so I choose not to take the effort.

SNIP
You are welcome.
Greetings Bob,
I see from reading the post you replied to that 40,000 RPM is not
mentioned. Oops. About my reply sounding adverserial I did not mean
it to sound adverserial. But after reading it I can see how it may
have sounded that way. Sorry about that. It was certainly not my
intention to insult or in any other way offend you. I'm not being
flip. Too often folks here insult others when someone has asked or
replied to a question. It may sound stupid to someone but the person
asking the question didn't think it was stupid. My goal with the
spindle is to get something I can hold in the CAT 40 tool holder
without a lot of hang out. I do not want a spindle added to the side
of the main spindle. I did consider this at first and drew up a clamp
arrangement but didn't like it. I also made in the past a spindle that
mounts in an NMTB 40 holder and uses a belt drive to a motor mounted
off to the side. And though it works OK I have really never liked it
much.
Cheers,
Eric

---
This email is free from viruses and malware because avast! Antivirus protection is active.
http://www.avast.com