On 2/13/2014 1:06 PM, woodchucker wrote:
I have a problem with my model here.
I have drilled a hole through the side, in Xray mode it looks correct,
but in 3d solid it does not. I did it the same way I did the top drill
through, so what is going on here.

It looks like you didn't use the push/pull tool far enough to break the
outside faces of the block with the circle you used to push through to
get the hole?

In order to get a circular hole through both sides of solid, you need to
make sure you go all the way to the outside face of both sides ... just
like you do with a drill.

If that is not the problem, can you make the model available for download?


--
eWoodShop: www.eWoodShop.com
Wood Shop: www.e-WoodShop.net
https://www.google.com/+eWoodShop
https://plus.google.com/+KarlCaillouet/posts
http://www.custommade.com/by/ewoodshop/
KarlCaillouet@ (the obvious)