On 2/5/2014 12:55 PM, dpb wrote:
On 2/4/2014 11:45 AM, dpb wrote:
On 2/4/2014 9:36 AM, Leon wrote:
...

Then how do you deal with the inside corners, if you use the router?

Either leave or more commonly touch up by hand, obviously.

Which is, of course, no different in principle than if use the block
plane or other hand tool for the purpose ...

--




FWIW I considered the original OP's comment to " knock down" the corners
so that the finish would adhere better to mean simply make the edge less
sharp, not to add any kind of profile to the edge. There was no mention
of adding a profile in the original post.

And if that were the case you might as well sand everything, the edges,
lightly rather than use a tool for the same purpose and still have to
hand sand the corners.

But if you are changing the profile then you would truly and obviously
have to touch up by hand.

Sorry