DIYbanter - View Single Post - Newbie question: How to make finger joint cut

wrote:
Any opinion on these saws would be appreciated; unless the opinion is
"waste of money, you need to spend 500 pounds at least" - remember what
I'm currently using guys!!! I'm sure the Perform (axminster link above)
table saw sounds a billion times better...

heavier is better. flip them over and look at the undercarriage. see
which one has the least number of loose parts G

It's a bit difficult to flip them over without seeing them, but I take
your point. If I get it and it rattles it'll go back ;-)

Cheers,

Andy