OT need step by step on this alternator/pulley/belt replacement
On Sat, 25 Jan 2014 18:17:18 -0700, RobertMacy
wrote:
On Sat, 25 Jan 2014 17:34:29 -0700, Lab Lover wrote:
...snip...
You are welcome. This should be fairly simple. Just remember, if the
primary
wire to the alternator fastens with a nut to a thread stud, DO NOT over
tighten
this nut. I would estimate 10 - 15 ft/lbs. This connection is usually
made
directly to a diode.
duly noted. don't have a torque wrench, but will only tighten until just
before I hear that distinctive 'crunch'
You can use a star washer behind the terminal. It snugs up swell,
without much torque.
http://tekfastners.com/images/star-washers-833443.jpg
--
"There's nothing like the scent of Cordite in a woman's hair."
|