On Sun, 1 Dec 2013 12:51:06 -0800 (PST), jullian browne
wrote:

On Sunday, December 1, 2013 3:44:32 PM UTC-5, Oren wrote:
On Sun, 1 Dec 2013 12:00:02 -0800 (PST), jullian browne

wrote:



Now i just cleaned all the dust in the furnace abd its still not coming on but the pilot light stays lit.



Reset the factory default values on the T stat EPROM?.



Start from there...a paper clip to push the reset button.

Where is that at?

At a button - or a hole; perhaps on the back of the unit. I can't see
it from this view. Never read your manual, either.

OR:

"...Set the T-stat to "off," install batteries backwards for five
seconds. Remove batteries and reinstall correctly. This should reset
it to factory specs. After that you'll have to reprogram it. "