"Edwin Pawlowski" wrote in message

OK, now for the questions. The front I plan to make a straight vertical
strip about 2" high and then set the face at about 15 degrees. Any reason
not to? Speakers will be mounted side by side.

I'm planning to use biscuits and glue it together.

Personally, I would use rabbet joints, glue and screws on speaker boxes ...
most of the top end speakers are made this way.

Should I make one of the
panels in two pieces, leaving a section unglued for access to wires? I'd
just screw it in place and use some sort of gasket material.

Probably not necessary. You can generally access the wires and mounting
plate, crossovers, etc through the opening for the speaker itself.

--
www.e-woodshop.net
Last update: 5/15/04