On Wed, 06 Nov 2013 15:11:05 -0800, Larry Jaques
wrote:

On Wed, 06 Nov 2013 11:32:13 -0800, Gunner Asch
wrote:

On Wed, 06 Nov 2013 08:04:29 -0500, bobm46 wrote:

On 11/5/2013 10:36 AM, Dave, I can't do that wrote:
Hi All,

Getting cold out here, snow on the ground overnight. I probably should put this on a woodworking group, but I like to always ask here first as you guys seem to be able to cover more/every topic.

I am using a water-based glue to assemble a large wooden project and I am brushing on the glue with a 2" paint brush.

I need to be able to keep the paint pot warm. I am thinking of an immersion heater with thermostat for about 100F. I am thinking that if I have say, 3" of water in the bottom of the heater pot, I can then sit the glue pot in that and convection will do the rest for the glue in the inner pot.

Anyone know of a cheap 110v immersion heater with fixed or (adjustable) thermostat I can use to make this pot-warmer? I picked up an old lead melting pot at a yard sale for $5, but it does not go down low enough and the water boils away in about 10-minutes. I also tried our electric kettle, (don't tell momma {gasp}) but same again, it has no "warm," setting.

I also found some heaters for science labs but I'd have to re-mortgage the house for one.

Thanks

When I make jewelry I use a flea market crock pot to heat my pickle. It
has a "warm" and a "hot" setting.

I could have gone for the rest of my life without pondering the above
statement.

Um, I think he meant "pickling solution for metal patination", G-mon.


http://www.newmalecontraception.org/heat-methods/

Fried balls? Yeouch!


Grin


--
Liberals want everyone to think like them.
Conservatives want everyone to think.

---
This email is free from viruses and malware because avast! Antivirus protection is active.
http://www.avast.com