"Doug White" wrote in message
. ..

I need to make a replacement pin for a Russian target pistol (a TOZ-35M
free pistol). The pin is the pivot for the Martini action block.

The pistol has been quite functional for a couple of years using the stem
of a cotton swab, but it looks tacky. I don't think the pin needs to be
hardened, but the official one has a groove in it that a spring detent
snaps into. That will wear over time if the pin is too soft.

I'm going to order some 4mm drill rod, and have the option of A2 or O1
steel. If I don't bother hardening it, is there any advantage to A2? I
can't seem to find any info on what the hardness of the two are in their
annealed condition. A2 has some chomium in it, and I'm guessing it might
hold up a tiny bit better.

Thanks!

Doug White


Can you find a drill bit that's same diameter. use a
grinder to cut off some of the non-fluted shaft.
Chamfer the ends, as needed. How long a pin?

--
..
Christopher A. Young
Learn about Jesus
www.lds.org
..