Thread: just found this group and have a question...
View Single Post
  #4   Report Post  
Posted to rec.woodworking
Dr. Deb[_2_] Dr. Deb[_2_] is offline
external usenet poster
  
Posts: 50
Default just found this group and have a question...
wrote:

I'm building a jewelers bench for my wife. And I'm cutting dadoes for 1/4
walnut ply panels. And was wondering how deep should the dadoes be?

It all depends on the walnut and its use. If you are using 1/4" walnut to
divide pigeon holes, a quarter inch is plenty. If its structural, you will
need 3/8", assuming your cutting them in 3/4" inch stock.
Reply With QuoteReply With Quote