On Sat, 19 Oct 2013 06:02:31 -0700 (PDT), stryped
wrote:

I read that some people have taken their mig welder and turned it into a tig by drilling out a mig tip. Then they drill and tap the side to install a set screw. The tip then will hold a tig electrode to use. Anyone ever done this? Does it work?

No it wont work. At best..it may give you a "spot welder"...but not a
tig.


--
"Their mommies tell them they're special, Liberals just don't understand
that "special" is a polite euphemism for;
*window licker on the short bus*"

---
This email is free from viruses and malware because avast! Antivirus protection is active.
http://www.avast.com