On 9/16/2013 4:44 PM, Puckdropper wrote:
dpb wrote in :
Agree, the noise is friction losses--_a_bad_thing_ (tm)
I've been using thinwall DWV plastic (Sch 30 or even 20) and excepting
for the static electricity annoyance(*) works fine as well.
(*) But it's no worse than the flex plastic, either...
I wrapped some wire around my planer discharge chute because of the
static. One end is grounded to the body of the planer. It helps quite a
bit.
Bill Pentz's site had a recommendation of putting a piece of metal tape
down the pipe on both inside and outside then connecting them with a
through bolt. Sounds like it worked well.
http://www.billpentz.com/woodworking...atic_electrici
ty
Puckdropper
My hose is long enough that it is always in contact with the concrete
floor. That contact seems to take care of static discharge as I can't
remember ever being shocked by the hose. A different climate might have
different results.