Gooday and how are you. I am writing from the land downunder.
I have recently bought a new dovetail jig (made in aussie land of
course) that rides on a router table.

The manufacturer also includes a table plan to make which fits into
the specs that you suggest (ie DIY). I think the plan is available on
line at www.gifkins.com.au. this table is only good for routers with 3
or 4 screws holding on the base plate

Just out of interest i have fiddled with dovetai ljigs for a couple of
years and when i picked this one up at the sydney wood show recently
my first attempt was nearly perfect, closer than any other jig had
come.

Take care. Arthur A.

On Mon, 28 Jun 2004 20:45:08 -0500, "Charlie Mraz"
wrote:

I have some questions regarding router table fabrication. I am in need of
an upgraded router table, and I have several options before me. I have a
tablesaw with an MDF/plastic laminate extension on BOTH sides, so there are
two possible locations. Thirdly, I could use some of the leftover laminate
(I bought a whole 4'x8' sheet and have about 4'x16" left) and MDF to make a
separate table top. That, of course, opens up several possibilities for
bases from folding sawhorses to hardwood legs, to a fully enclosed cabinet,
with or without storage, etc. What I have decided on is that I will not use
a plate. I prefer the smooth uninterrupted surface of a plateless top. The
router to be mounted is a P-C 8529 plunger. The questions that most concern
me are the details of mounting the router to the top. Is the preferred
method to relieve the underside in the shape of the base? To what
thickness? What about screws? I have had bad luck with flathead screws
pulling right through MDF before. Would a counterbore and panhead screws be
any better? As a point of information, I have read Pat Warner's webpage,
which is very informative, but leaves out several of these small details.
Also, what about provisions for template bushings? I believe the proper
opening is 1 9/16? What about depth/thickness? Any
information/opinion/reference/etc. will be greatly appreciated.

Charlie