View Single Post
  #32   Report Post  
Posted to rec.crafts.metalworking
[email protected] dcaster@krl.org is offline
external usenet poster
 
Posts: 3,984
Default Set screws on hard shaft

On Tuesday, September 10, 2013 9:46:17 PM UTC-4, Tom Gardner wrote:




Yep, but no room at 90. I figure that opposing is better than 1 screw.


Actually it is not much better. Think of having two men pulling against each other on a rope. Now tie one end of the rope and just have one man pull. The tension in the rope is the same in both cases.

Is the part long enough that you can put two set screws both at the same degree.?

Dan