On Sat, 7 Sep 2013 19:52:38 +0200, nestork
wrote:


Futher to a previous post:

If the hole in the carb is about 1/10 of an inch, can you not buy a
piece of 1/10 inch diamter brass tubing (at any hobby shop for use as
steam pipe for miniature steam engines or fuel line for miniature IC
engines) and file or grind half of it off so that it will fit inside
that "D" shaped hole?

How would that keep it from spinning on the "D"? Seems it would just
spin, unless it latched on somehow? Pinch the tube little, maybe?