Guv Bob expressed precisely :
Greetings! I had to take a break from the timer project....

Now I am troubleshooting an electric window circuit. The drivers side works
fine. Passenger window motor will not energize. I have already checked the
entire circuit from the ignition switch to the input to the motor and
switches and 12V circuit are fine. rocker switches both send 12V to the last
connector shown on this diagram at the motor -- see bottom right on this
diagram from Haynes... http://imageshack.us/a/img849/8915/70dr.jpg

The window is down and I can't figure out how to raise it so I can pull the
parts out.

Before I do that, I want to check to be sure the motor is grounded, but can't
find any schematic showing where the ground is connected.

Anyone have an idea where it could be grounded?

FYI, here's page one of the window circuit.
http://imageshack.us/a/img841/6729/qiq8.jpg

I thank you and my wife thanks you.

Bob

From circuit on 70dr.jpg.
The motor is not grounded. The only ground is that supplied by one or
other of the wires 2RB or or 2GB depending on UP or Down Switch that is
motor terminal 1 or 2, these connections are reversed by the switches
above to give UP or DOWN.

Make sure both ON/OFF switches are ON l-)
Ground is the wire doewn the centre of the page labeled 2B.

--
John G