Thread
:
peening to tighten thread
View Single Post
#
3
Posted to rec.crafts.metalworking
[email protected]
external usenet poster
Posts: 2
peening to tighten thread
On Thursday, August 22, 2013 9:35:34 PM UTC-4, Karl Townsend wrote:
On Thu, 22 Aug 2013 18:25:06 -0700 (PDT),
wrote:
I am finishing up a bench for a Southbend 9B.
The top is strapped at the ends with bar stock
and bolted through with 1/2" - 13 stock.
The last 36" length of rod has a thread on which
the nut runs "loose." There's too much play and I'm
not in a position to take it back.
Can I improve the grip of the nut by slightly peening
the thread on the 12" - 13 stock - at select places gr?
Comments? Suggestions?
Thanks,
- Carl H.
You own a lathe. Make a tight fitting nut.
Karl
Thanks Karl.
- Carl H.
Reply With Quote
[email protected]
View Public Profile
Find all posts by
[email protected]