On 8/15/2013 2:56 PM, Karl Townsend wrote:
Got the old mower all tore down. New bearings due this evening.

One of the old bearings was turning on the hub at the OD. Not too much
wear but a new bearing is going to slide in there and still have room
to rotate.

I'll take a center punch and do a poor man's knurl job on the hub. But
I've seen that give out after a while. there must be some product to
lock it in place. "Locktight Super duper never let it go"

Any suggestions?

karl



Old school: I'd wrap it in shim stock.