ljaques wrote:

On Tue, 02 Jul 2013 16:18:02 +0000, Safeman
wrote:

I need to source 90 of 9/16 UNC flush headed countersunk
bolts/screws
overall length 2" and 10 of the same but overall length
2.5"

It doesn't matter what type of drive they have and preferrably
threaded
the whole way, I could live with 1/2" unthreaded shank.
Any more than that I guess would be acceptable, just a lot of
thread
cutting for me to do....

Anybody help, I have run out of ideas...

You didn't mention where you are or where you've looked (of course
sigh) so I'll just say...

"Check with local fastener houses. Around So Or, it's Sasco.
http://www.sascofasteners.com/ . If your local distributor doesn't
stock them, they can find them for you and it will cost you 1/3 to
1/10 of what it would cost at hardware stores. Barring that, googlit.
Good luck!"



--
Sorry, I'm based in the UK and tried all local suppliers and google but no
joy yet, I am rebuilding a very big old safe
and I had to drill out all the original bolts, thanks for your input.

--


--
posted from
http://www.polytechforum.com/metalwo...ts-579135-.htm
using PolytechForum's Web, RSS and Social Media Interface to
rec.crafts.metalworking and other engineering groups