Sonny wrote:
On Sunday, June 9, 2013 4:12:58 PM UTC-5, Leon wrote:
Now think of making hundreds as the company that builds this unit does,
think gang boring might ease production effort?

Well, yes, when they're being mass produced.

Sonny

I do agree that probably with less setup trouble and cost, drilling holes
for a hand full of cabinets would best be done with already available
tools. But I knew that these particular cabinets were being mass produced.
The cabinet appears to be pretty well constructed and the joints are very
good but the use of the piano hinges and lack of a decent finish is a
little hard on the eyes. The piano hinges used in this orientation is an
open invitation for sag, and the doors already have a bit of sag. In
anticipation of this I beveled the front and extended the front of the
"step up" to help realign the door fronts when returning them to the closed
position.