On 2013-06-06, Bob La Londe wrote:
"Bob La Londe" wrote in message
...
I recently acquired a Yuasa spindle speed multiplier with a straight
shank. Woo! Hoo! The seller had said it had a 3/4 shank, and I already
had a couple 3/4 Kwik 200 holders. Alas! As soon as I opened the box I
knew the seller didn't own a caliper.... or even a ruler. LOL.

I had to chase down a 1" holder for the Hurco, but now I have the ability
to turn upto 10,000 RPM. Knowing these speeders are hard to find, and new
ones are expensive I want to take care of it. There is nothing in the box
resembling documentation, so I was wondering about lubrication, bearing
replacement (if needed), other service, power handling capability, etc.

Anybody have good direct knowledge of these or even a manual they could
scan and forward? Be willing to share?

Thanks,
Bob

Even just a decent recommended service and interval would be appreciated.




I just wanted to say congratulations, this one thing will expand your
mill's capabilities by so much! I am also looking for one.