On Thursday, April 25, 2013 2:59:01 PM UTC-5, dadiOH wrote:
wrote:

On Monday, April 22, 2013 7:16:57 AM UTC-5, wrote:

I got my new rail and stile bits out this weekend and put them on my

ryobi router table and started playing with them. The bits seem to

sit too high, I cant get the right profile on my 3/4 inch thick

wood. On the stiles the ogee pattern is past the middle of the

tickness of the wood. And becasue of this there is no groove put on

the wood.







My router is a ryobi r 181FB1. It has been in storage for awhile. I

had cleaned everythign up but I cant seem to make any adjustment for

the bit to go down. There is a locking ring I loosened, the

adjustment ring just moves a little before it stops. But this

movement does not seem to be doing anything to the hight of the bit.







Can anyone suggest what I am doing wrong?







I appreciate it!



No, it will not go up or down even with the baseplate removed.



Did it ever? Have you ever used it?





--



dadiOH

____________________________



Winters getting colder? Tired of the rat race?

Taxes out of hand? Maybe just ready for a change?

Check it out... http://www.floridaloghouse.net

Yes. I have had it for about 8 years. Alot of that it has been in storage under my router table however.