On Monday, April 22, 2013 7:55:02 AM UTC-5, CW wrote:
wrote in message

...



I got my new rail and stile bits out this weekend and put them on my ryobi

router table and started playing with them. The bits seem to sit too high, I

cant get the right profile on my 3/4 inch thick wood. On the stiles the ogee

pattern is past the middle of the tickness of the wood. And becasue of this

there is no groove put on the wood.



My router is a ryobi r 181FB1. It has been in storage for awhile. I had

cleaned everythign up but I cant seem to make any adjustment for the bit to

go down. There is a locking ring I loosened, the adjustment ring just moves

a little before it stops. But this movement does not seem to be doing

anything to the hight of the bit.



Can anyone suggest what I am doing wrong?



I appreciate it!

================================================== =======================

There is a locking lever that you have to loosen first. Go here for the

manual.

http://powertool.manualsonline.com/m...l?idRes=597983

I did loosen that locking ring.