"Gramp's shop" wrote in message
...

One of the maple boards on the buffet projects has a small imperfection.
It's a thin -- maybe 1/16th of an inch by 2 inch jagged scar that's about
1/16th of an inch deep. I recall reading that some folks fill such
imperfections with CA glue. What's the process? What impact does this
have on finishing (assuming use of a wipe on oil-based finish)? Any other
suggestions?

Is this a "natural defect" or man made damage? If a natural defect such as
a bark inclusion or split perhaps celebrating the defect by filling with a
very dark brown, even black, tinted epoxy would be the way to go. It would
end up looking like a smooth bark inclusion under the finish. Many of the
high end turners and flat boarders I know use this technique to "fix"
splits, loose knots, etc. and it looks quite natural.

If a man made defect, such as a ragged dent or scratch, I'd try steaming it
several times to see if the damage raises and then reassess the situation.
It may revive enough that another round of sanding the entire surface
removes the defect. I wouldn't spot sand as it could leave a depression...

John