On Sun, 24 Feb 2013 01:45:33 -0500, "Steve W."
wrote:

Steve B wrote:
I want occasionally to bend a piece of flat bar no more than 6" wide, and
3/8" thick. Sometimes if is a random angle, and sometimes, standard 45 and
90s. Are there dies available that I can put in a bench press with a
hydraulic pump, and make these pieces when I need them? Are any readily
available, or what would it cost for a machinist to make me a set that would
do up to 90 deg? They got that stuff @ HF?

Steve



like these?
http://www.youtube.com/watch?v=5g8D65JwhuE
http://www.youtube.com/watch?v=iFXZgiXX_mA
http://www.youtube.com/watch?v=4Ey5DHMYLZg
http://www.youtube.com/watch?v=mn1GsAJcpok
http://www.youtube.com/watch?v=jDgPiH2eyiw




http://www.northerntool.com/shop/too...duct_7902_7902


Some of those are pretty well done! Time for me to build one!

Gunner

The methodology of the left has always been:

1. Lie
2. Repeat the lie as many times as possible
3. Have as many people repeat the lie as often as possible
4. Eventually, the uninformed believe the lie
5. The lie will then be made into some form oflaw
6. Then everyone must conform to the lie