Steve B wrote:
I want occasionally to bend a piece of flat bar no more than 6" wide, and
3/8" thick. Sometimes if is a random angle, and sometimes, standard 45 and
90s. Are there dies available that I can put in a bench press with a
hydraulic pump, and make these pieces when I need them? Are any readily
available, or what would it cost for a machinist to make me a set that would
do up to 90 deg? They got that stuff @ HF?

Steve



like these?
http://www.youtube.com/watch?v=5g8D65JwhuE
http://www.youtube.com/watch?v=iFXZgiXX_mA
http://www.youtube.com/watch?v=4Ey5DHMYLZg
http://www.youtube.com/watch?v=mn1GsAJcpok
http://www.youtube.com/watch?v=jDgPiH2eyiw




http://www.northerntool.com/shop/too...duct_7902_7902

--
Steve W.