On 2/14/2013 9:30 AM, Ivan Vegvary wrote:
Putting up hundreds of feet of MDF trim. (1/2" casings, baseboards etc.) Using 2" finish nails in the gun. Only about one in nine nails sets below the surface. Pain in the ass to bend and set nails at odd angles, even though I can swing a hammer with either hand.

Gun pressure set to 90 psi. Any suggestions? Buy a better gun? Would lubricating the nails help.
BTW, the nail heads are proud by about 1/32".

All advise appreciated.

I'd crank that puppy up to at least 100psi, if not 110 and see how that
works.

Remember, if you start at 90, and depending upon how you have your
compressor to kick in, you are probably shooting at a lower pressure
than your setting after the first few shots.

--
eWoodShop: www.eWoodShop.com
Wood Shop: www.e-WoodShop.net
https://plus.google.com/114902129577517371552/posts
http://www.custommade.com/by/ewoodshop/
KarlCaillouet@ (the obvious)