Snowblower Problem Question ?
On Feb 10, 3:29*pm, DerbyDad03 wrote:
Jim Elbrecht wrote:
wrote:
On Sun, 10 Feb 2013 12:50:56 -0800 (PST), Bob_Villa
wrote:
-snip-
I would add the simplest possibility is sheared auger pins and they are
not moving snow to the middle for pick-up and are just snug enough to
turn when not under load.
HTH
I said IF the auger is turning and the impeller is NOT turning on an
Ariens 2 stage, the pin is gone. NO OTHER OPTION . period.
Correct-- *But* - The OP said he couldn't tell if the impeller was
turning. * so it might be-- and then what Bob says *is* the Occam's
razor choice.
If the augers stop under load it is a different story - could be a bad
belt, tensioner, or auger shear pins. *Not common to shear both *(or
all 4) pins at once
No-- but I've seen people going up and down their driveway with one
augur turning, blissfully unaware that one is sheared. * * Until the
second one goes-- then they know something isn't right.g
Jim
Jeez. Now I have to keep a mirror in my garage to make sure both augers are
turning.
I wonder if Ariens carries one as an accessory.
Common bolt will "work" but it takes more force than a real roll pin
does to shear it. If Ariens puts a rollpin in there then something
will break before it shears.
Harry K
|