Bill wrote:


And always 15-degrees! I noticed that the Harbor Freight one
provided 2 different angles. I don't own either, so I am watching
this thread with interest.

The two different angles are for different stock thickness. One is for 1x
and the other is for 2x. It can do 1/2 also, but you use the same guides as
the 1x.


Dare I suggest: How about buying the drill bit and the screws and
making one's own jig? With all of the engineer's around here it
would seem to be practically child's play! : ) I might use
masking tape on the drill bit to mark the level to drill to. At
least for occasional use, this would seem to be more practical than
forking over $100+.

$69 at HF. You could make one, but the key is the hardened steel guides.
By the time you get done farting around making one it's probably cheaper to
just pay the $69 and be done with it. Some wheels just aren't worth
reinventing.

--

-Mike-