On Thu, 17 Jan 2013 23:34:41 -0600, Leon lcb11211@swbelldotnet
But to answer your question, I do not miss cutting full sheets of
plywood on my TS. I did that for about 25 years and wish I'd had this
alternative 24 years ago. Keep in mind that the track saw could replace
the TS if quality of cut was the only factor.

I ask these questions in relation to my wheelchair. I can sit and feed
sheet plywood through the tablesaw, but I can't move and run a track
saw through plywood at the same time. I wish it was otherwise.

Two years ago, I bought a TS55 to see if there was some way I could
use it, but ended up exchanging it for an hl850e planer.

The only tracksaw method I can think of using is one of the self
feeding types. The Mafell PSS 3100e is an example. And, despite the
horrific cost of approximately $3000, it's something I'd seriously
consider.

http://www.core77.com/blog/tools/fro..._saw_24165.asp