klem kedidelhopper wrote:
On Jan 8, 1:40?pm, Cydrome Leader wrote:
klem kedidelhopper wrote:
We need to run video over some existing CAT5 cables using baluns on
either end. The existing cables are all terminated with jacks on both
ends. One end is a patch panel and on the other end they are connected
to jacks which are mounted on the baseboards. We plan to make 8 foot
cables with an RJ 45 on one end, plug it into the baseboard jack, run
the cable up the wall and then connect the other end to the balun and
then to the camera. Would it matter if this short piece of cable were
CAT3? Thanks, Lenny

why would you use cat3? Also where do you even get cat3 unless you're a
copper thief these days?

I'd use silver satin, or some 1980s 50 foot coiled kitche telephone cords,
with a handset swivel thingy on it, with nothing but the finest and most
reasonably priced rj11 to rj45 adapters from Black Box.

Well the obvious reason to use CAT 3 is because as a former telephone
systems contractor I happen to have a **** load of it and I didn't

well hell, use some double cotton covered wire then.

want to have to buy any additional CAT 5 at this time. Was that so
difficult to figure out? Most people that visit this group are not

It was foolish for me to to assume most people have bought cable in the
past 20 years.