On 12/03/2012 03:04 PM, tiredofspam wrote:
On 12/3/2012 4:43 PM, Brooklyn1 wrote:
isw wrote:

If you have some way to make a lot of sawdust (power sander) then do
that, using the cutting board as a source -- it probably could use a
resurfacing anyhow. Mix the dust with epoxy to make a thick paste, and
work that into the cracks.

Why micky mouse around when for a couple three dollars you can buy
wood filler:
http://www.dap.com/product_details.aspx?product_id=69
http://www.minwax.com/wood-products/...FedxOgod1w4AIg


because wood filler will not work.

it shrinks, does not stick as well as epoxy...
and has other downsides.

As far as rejointing it, we don't know if this person even has the
equipment to do that. I think this was someone outside the group asking
for advice.


All he needs to do is rip it down the center of the glue line on a
tablesaw (or with a guide and a circular saw) and re-glue it.



--
"Socialism is a philosophy of failure,the creed of ignorance, and the
gospel of envy, its inherent virtue is the equal sharing of misery"
-Winston Churchill