On Oct 29, 4:00*pm, thescullster wrote:
Hi all

One of my colleagues was asking what these flexibles were made for
specifically. *He had seen flexible connectors with compression fittings
one end and just a plain 50mm long 15mm o/d pipe-type end at the other.

Clearly you could stick a compression fitting onto the straight end, but
he thought he had seen these mentioned alongside a monobloc tap.

Are there taps out there with connections which just accept a plain
push-in pipe end? *Maybe with an O-ring seal joint like plastic pipe
fittings?

Sounds easier than wielding a tap spanner, but not sure how this joint
would be dismantled.

TIA

Phil

You could solder it.

You could use it with push-fit.

You could stick it ... anywhere you would otherwise use plain pipe.

MBQ