Well now that I know what the quill is and the diameter, I should be able to
figure it out now. I downloaded the manual for the Delta. I do understand
that they appear to shim for smaller diameters, so I'll measure it, check
the specs and buy it, in the least I'll take it back to
home-depot...........................Thanks, Again



"AArDvarK" wrote in message
newskcic.20278$432.1124@fed1read01...

"130.81.64.196" wrote in message
...
Thanks, I've looked at both just couldn't match up the specs between both
to
see if compatible. It looks like they're made to be mated to various
drill's
so most likely will work and really couldn't find any other then Delta &
Jet. I got that quill down now.

I'm making some furniture and initially really had the hot's to get the
mortising kit, but fustrated went out and bought wood chisels. Not too
bad,
got it down to 10 minutes per hole.

Thanks, Again!

Joe

It should work fine if you can loosen the quill position locking
[mechanism - nut] and reposition it to accomodate the attachment,
then re-tighten it. It's only this: The quill size has to be compatible.

Alex